Instructions for Use

15L with inhaler cap

 1. Lay trigger flat against top of can

2. Press inhaler cap to mouth with trigger pointing to chin and the notch under nose.

3. Depress trigger with thumb for 1 second at the beginning of breath and release. Continue inhaling without oxygen flow and complete full breath.

4. Repeat 5-10 times and then wait at least 10 minutes before subsequent use.

Repeat as required throughout the day.

15L with mask and tube

  1. Insert tube onto nozzle on top of can.

2. Place mask over mouth and nose and secure elastic at back of head.

3. Remove white protective cap from top of can.

4. Depress actuator button for 1 second at beginning of breath and release. Continue inhaling without oxygen flow and complete breath.

5. Repeat 5-1o times and then wait at least 10 minutes before subsequent use.

Repeat as required throughout the day.

110L with valve, mask and tube

1. Insert tube onto nozzle on top of green regulating valve.

2. Remove white protective tab from the top of the canister.

3. Place mask over mouth and nose and secure elastic at back of head.

4. Screw regulating valve clockwise onto canister. At a point the oxygen will start to flow. Screw tighter or looser to adjust flow.

5. Take 8-10 breaths and unscrew regulating valve counterclockwise to stop flow.

During storage remove regulating valve entirely to prevent accidental leakage.

10L with Spray Cap

 1. Remove protective cap

2. Hold spray nozzle approximately 3 cm/1 inch from mouth.

3. Depress spray nozzle with finger for 1 second at the beginning of the breath and release. Continue inhaling without oxygen flow for a full breath.

4. Repeat 8-10 times and then wait at least 10 minutes before subsequent use.

Repeat as required throughout the day.